Single phase 100V Screen diameter φ255 Stroke X60Y60mm Projection lens X10 included Stage φ65 Digital included Reflector lens ×

Cutter diameter 80Φ Spindle speed 100-1000rpm Table stroke 160mm

With mass

FANUC15-M Screen size 400 x 500 Table size 250 x 300

110t Stroke number 35-65 Stroke length 180 Die height 350 Slide adjustment amount 90 With light stabilizer

80t Stroke number 37-75 Stroke length 130 Die height 350 Slide adjustment amount 80 Slide dimensions 550 x 450 Bolster dimensions 1000 x 600 x 140 With light relief With die cushion

Chuck size 600 x 400 Fully automatic with automatic cutting ★ Test cutting has been carried out! (Photos are available)

Capacity: 1000L Maximum operating pressure: 9.0kgf/cm2 Water pressure test pressure: 13.5kgf/cm2 The photo shows the product in an uncleaned condition.

7-inch 3-jaw scroll chuck (Kitagawa/JN07) with 2-axis digital scale

20t Stroke 1600 *With blade (blade length 730, diameter: approx. 90Φ)

13×1260 Electric clearance Auto back gauge Machine weight 9.4t

25t Table length 1250 Stroke length 100 Gap depth 200 Open height 325 Stroke length 100 Manual back gauge With light stabilizer *This is a machine that was used at school.

Punching: Pressure 50t Diameter 25 x Thickness 16 Angle 90°: 13t x 100 x 100 Flat cutting: 90°: 9 x 75 x 75 45°: 9t x 75 x 75 Bar cutting (round bar) 32φ (square bar) 28φ Shearing: Thickness 9 x Width 305 Notching: 9 x 75 x 75 With tracing *60Hz specification (can be changed to 50Hz/additional cost)

FANUC-15M BT50 ATC90 Spindle speed 4000rpm Table size 2500×1100 Stroke: 2500 Y1300 Z 800

7-inch 3-jaw scroll chuck, center distance 550, spindle speed 83-1800 rpm, spindle through hole diameter 35, swing above bed 360, swing above carriage 210 *This is a machine that was used at school.