Upper die: Length 835mm, angle 30°, height 97mm, effective height 66mm, pressure resistance 100t

Upper die Length 835mm Angle 30° Height 97mm Pressure resistance 100t Hemming punch

Upper type Length 670mm Angle 90° Height: 130mm Pressure resistance 30t R0.2 For sashes

Upper die Length: 785mm Angle: 30° Tip R: 0.52mm Effective height: 64.3mm Pressure resistance: 100t Hemming punch

Upper die Length: 835mm Angle: 30° Tip R: 0.52mm Effective height: 64.1mm Pressure resistance: 100t/m Hemming punch

Upper die Length: 835mm Angle: 30° Tip R: 0.52mm Effective height: 65.5mm Pressure resistance: 100t Hemming punch

Upper type Length 415mm Angle 88° Height 99mm Effective height 69mm R0.2 Sash

Die holder length 830mm top width 14mm bottom width 60mm height 100mm

Length 400mm Punch roll width φ60 Die roll width φ30

Upper mold, special mold, length 835mm, height 100mm (set with A115584, etc.)

Upper mold, special mold, length 835mm, height 100mm (set with A115584, etc.)

Upper die Length 835mm Effective height 63mm Angle 30° Pressure resistance 100t/m Sharp angle for hemming

Type: Upper type Length: 585mm Angle: 90° Height: 125mm Pressure resistance: 12TON Split type: 10/15/20/40/50/200/300mm

Die holder length 855mm rail width 35mm width 60mm height 43mm

Type: Upper type Length: 515mm Angle: 90° Height: 97mm Pressure resistance: 100KN/3TON Split type: 300/50/165mm

Type: Lower type Length: 415mm V width: 8mm Angle: 90° Height: 30mm Pressure resistance: 65TON/M.20TON/FOOT